Dynamic DX2-ACU, Руководство по установке, Страница: 19 / 56

6.1.5 Tube mount
Figure 12: Tube mount (from above)
The remote module can be fixed on to a tube
using a suitable tube clamp. This solution is useful
for tubes that run perpendicular to the remote
module, as shown left.
The tube diameter will depend on the tube clamp
used, and also the fixing hole centres on the
remote module (30 mm). A tube with an outside
diameter of 15 - 22 mm would be suitable.
Use two M5 bolts to fasten the tube between the
clamp and the base. The maximum torque to
fasten these bolts is 3 Nm – do not exceed this
rating as it may damage the remote module.
Ensure that the DXBUS cable is not pinched when
tightening the tube clamp.
Figure 13: Fixing the tube mount
6.1.6 Drop-in mount
The depth and shape of the base of the compact remote module allows it to be placed into a suitably
designed cradle, such as the drop-in mount shown in
Figure 14 .
The drop-in mount is ideal for the DX2-ACU attendant remote module, allowing an attendant to
remove and replace the module with ease, and also use the module at a comfortable, safe distance
from the wheelchair. Design the mount to prevent the remote module from falling out accidentally,
or twisting around when used in the mount. A concept drawing is shown below.
Figure 14: Concept drawing for drop-in mount
GBK65701 DX2 Compact Remote Modules
Installation Manual Issue 1
Installation - Page 17