Install Video at
www.DynamicMounting.com/Install
12
12
Adjusting the Counterbalance
The Mount comes out of the box set around the 65 LB TV setting and will
need to be adjusted for the mount to work properly with your television. To
adjust the counterbalance, turn the bottom of the counterbalance screw with a
9/16” box or ratcheting wrench, see Figure 15. This moves the
Counterbalance Block up and down. The approximate counterbalance block
settings for various television weights are shown in Figure 16. In Figure 16 the
counterbalance is approximately set for a 65 Pound Television.
To be able to move the mount without a TV on it, you need to move the
Counterbalance Block to the Minimum Counterbalance Force. At this setting it
will still take 15 to 20 pounds of effort to move the mount which is harder than
you think. You should secure it to something to get the mount to move. Once
you put a TV on the mount, everything will work much better.
Figure 15, Adjusting Counterbalance
(Detail
from Figure 2)
Figure 16, Counterbalance Settings
(Detail from Figure 2)
