Install Video at
www.DynamicMounting.com/Install
9
9
This Page is for attaching the Single Stud to the wall (No Frame).
Note: The Single Stud Mount has a reduced Max Load of 70 lbs;
this is because a
single stud isn’t strong enough to hold more, the mount is strong enough so if you are attaching
to something stronger than a single stud, the mount can handle more weight.
Conditions for Mounting Single Stud to the Wall
1.
The TV must be centered on the mount to avoid leaning.
2.
The mount must be centered on the stud.
3.
The mount is designed to attach to standard 2 x 4 or larger wall studs. If the wall isn’t sturdy enough then more support will need
to be added, consult an expert.
4.
The mount must be securely fastened to a structure that can support 4 times the total weight of the television and mount.
Dynamic Mounting assumes no responsibility for damage from an improperly installed mount.
5.
The mounting holes need to be in the center of the studs, use a stud finder as needed.
6.
2 lag screws are needed in the top slots of the mount and 1 in the bottom slot.
Important: The TV needs to be centered on the mount to avoid leaning
Mounting Single Stud to the Wall
The top two lag screw slots are covered by the mount and needs to be actuated to be able to access them. Figure 11 show the steps to
successfully attach to the wall.
Figure 11, Mounting Single Stud to the Wall
