Page 4 Electronics Design • Manufacturing Services
Product Description
For development or production use the PMC2PCI card to install a PCI form
factor device into a PMC compatible slot. Use less expensive or off-the-
shelf components until your PMC card is ready or for temporary debugging
situations. For production mode situations the available riser card will
reduce the effective height of the installed PCI card. The PMC2PCI is
64/66 capable and compatible with 32/33 systems. Both VIO voltages
are supported.
Special features
:
• Single width PMC card with blank bezel.
• 10
Ω
series resistors on the A/D bus
• Clamping diodes on the control interface signals
• Zero delay buffer on clock.
• 3.3 and 5V PCI slots are on the rear of the card PMC Host sets the
signal levels.
• LEDs on key voltages
• Onboard 10 A switching regulator for PMC 3.3V supply
• Shunt selectable regulated or slot provided 3.3V
• Slot selectable secondary VIO reference voltage.
• 32 or 64 bit operation – PMC Host must support 64 bit operation for
that width to work in the PCI slot
• 66 or 33 MHz operation. PMC Host clock speed supported up to 66
MHz.
• JTAG programming support for PCI slots
• Busmode set to respond to PMC.
The PMC2PCI is ready to use with the default settings. Just install the
PMC2PCI onto the PMC slot and the PCI card into the PMC2PCI.
The only shunt selection is for the 3.3V source. Install for the on-board
10A regulator and open for the PMC supplied 3.3V power. The 3.3V
LED should illuminate in either case
.
The PCI sockets are keyed and labeled for 3.3 or 5V PCI cards. The PMC
slot only supports one PCI attachment. Only one PCI card should be
installed at a time to prevent conflicts. Select either the 3.3V or the 5V
slot. If your application requires one of each or two of the same type to be
used we can add a bridge to the design to allow expansion from one PMC
slot to at least 2 active PCI slots. Please contact Dynamic Engineering for
this option or any other custom modifications that your system may
require.
