Before you start
You must first decompress the modem drivers from the floppy disk supplied into
your hard disk.
1. Insert the floppy disk labeled “V.90/K56Flex FAX/MODEM Driver” into your
floppy driver.
2. Go to
Start-Run
. Browse to
My Computer–Floppy (A:)
. Highlight the file
UFM560.exe
, click
Open-OK.
3. Click
OK
to start the WinZip Self-Extractor. When asked
Unzip to folder
, either
enter C:\DynalinkUSB, or enter a new folder of your choice, and then click
the
Unzip
button. The driver files will be copied to your hard disk in the folder
DynalinkUSB, or the folder you have chosen.
Connect the modem to your PC
Connect the enclosed phone cable to the LINE jack of the modem and a wall
phone jack, then connect the enclosed USB plug to both the modem and a USB
port on your PC. Once the modem has been connected to your PC a prompt will
load – please proceed to Step 3.
USB Hub Users:
If you intend on using the modem via a USB Hub, the Hub must
be self-powered. The modem consumes more power than a bus-powered port
can normally supply. Self-powered USB Hubs, which overcome this issue, are
available from Dynalink.
Install the modem drivers
System will report that it has detected a new device Atlas Modem Board.
Windows XP:
Click
Next
. Select
Install from a list or specific location - Next
.
Browse
to the
folder C:\DynalinkUSB\winxp, or the folder you have chosen in Step 1 (3). Click
Next
. System will report
Found USB V.90 56k FAX MODEM
. If a compatibility
message appears, click
Continue Anyway
. Click Finish to complete driver installation.
Windows 2000:
Click
Next
. Select
Search for a suitable driver for my device – Next
. Click
Specify
a location
.
Browse
to the folder C:\DynalinkUSB\win2k, or the folder you have
chosen in Step 1 (3). Click
Next-Next
. If
Digital Signature Not Found
appears
click
Yes
to continue and
Finish
to complete driver installation.
1
2
3