3211 Fruitland Ave
Los Angeles, CA 90058
SPD-100 & SPD-100L
SIGNAL-POWERED
TACHOMETER
Calibration Manual
Rev. B
P/N: 145F-12040
PCO
– 00010648
(c) Copyright 2017, Barksdale, Inc.
All Rights Reserved
REVISED: AUG 16, 2017
IMPORTANT
– PLEASE READ BEFORE
PROCEEDING!
The Dynalco SPD-100 & SPD-100L Tachometers are
designed for reliable and rugged operation. These
products have been designed and tested to meet the
demands
required
in
many
industrial
locations.
Performance of this product is directly related to the
quality of the installation and knowledge of the user in
operating and maintaining the instrument. To ensure
continued
operation
to
the
design
specifications,
personnel should read this manual thoroughly before
proceeding with installation, operation and maintenance
of this instrument. If this product is used in a manner not
specified by Dynalco, the protection provided by it may be
impaired.
Dynalco® is a Barksdale® brand.
WARNING
Failure to follow proper instructions may cause any one of the
following situations to occur: Loss of life; personal injury;
property damage; damage to this instrument; and warranty
invalidation.
For clarification of instructions in this manual or assistance
with your application, contact Dynalco as below:
Tech Support:
or 1-866-227-8528
Customer Care:
or 1-800-835-1060
Or by mail:
Barksdale Inc.
Barksdale® and Dynalco® Products
3211 Fruitland Ave
Los Angeles, CA 90058
Follow all warnings, cautions, and instructions marked on and
supplied with the product.
Use only qualified personnel to install, operate, program and
maintain the product.
Educate your personnel in the proper installation, operation,
and maintenance of the product.
Install/calibrate
equipment
as
specified
in
the
installation/calibration
section
of
this
manual.
Follow
appropriate local and national codes. Only connect the product
to power sources and end devices specified in this instruction
manual.
Any repair is only to be performed by Dynalco using factory
documented
components.
Tampering
or
unauthorized
substitution of parts and procedures can affect the
performance and cause unsafe operation of your process.
All equipment doors must be closed and protective covers
must be in place unless qualified personnel are performing
maintenance.
