Accessories
Motor Disassembly/Assembly Instructions
(continued)
To Disassemble Valve And Speed Regulator Assemblies:
1. Invert tool and place in soft jaw vise or use 57092 Repair Collar.
2. Loosen and remove 01788 Screws (2) from 57373 Adapter.
3. Carefully remove 56672 Adapter making sure no parts fall to the ground. Pry off 54194 Muffler Cap and remove 54195 Muffler (3).
4. Remove 57343 Speed Regulator by detaching 98597 Retaining Ring with a pair of snap ring pliers. Remove 01024 O-Rings with a small screwdriver.
5. Remove tip valve and seal from handle.
To Reassemble Valve And Speed Regulator Assemblies:
1. Lightly lubricate 01024 O-Rings and slide them on 57343 Speed Regulator. Install through regulator hole on 56672 Adapter. Place 98597 Retaining
Ring on groove of speed regulator using a pair of retaining ring pliers.
2. Insert valve stem in handle and line up the hole in valve stem with hole in handle. Place 01464 Seal into handle . Insert tip valve so that the metal pin
passes through the hole in the valve stem. Install 01468 Spring (small end first).
3. Install 98597 O-Ring onto 56672 Adapter and place 56673 Gasket onto handle.
4. Gently line-up 56672 Adapter onto handle so no parts shift when tightening. Apply #242 loctite to 01788 Screws (2), install along with 01211 Lock
Washers (2) and 96421 Flat Washers (2).
Motor assembly is complete. Please allow 30 minutes for adhesives to cure before operating tool.
Note: Motor should operate at between 850-900 RPM at 6.2 bar (90 PSIG). RPM should be checked with a tachometer. Before operating, we recommend
that 3-4 drops of pneumatic tool oil be placed directly into the air inlet with throttle lever depressed.
Loctite
®
is a registered trademark of the Loctite Corp.
DYNABRADE
®
DYNABRADE, INC.,
8989 Sheridan Drive
•
Clarence, NY 14031-1490
•
Phone: (716) 631-0100
•
Fax: 716-631-2073
•
International Fax: 716-631-2524
DYNABRADE EUROPE S.àr.l.,
Zone Artisanale
•
L-5485 Wormeldange—Haut, Luxembourg
•
Telephone: 352 76 84 94 1
•
Fax: 352 76 84 95 1
© DYNABRADE, INC., 2000
PRINTED IN USA
Visit our Web Site: www.dynabrade.com
Email: [email protected]
96195 Motor Tune-Up Kit
•
Includes assorted parts to help
maintain and repair motor.
96283 Motor Repair Kit
•
Contains special tools for use of
Disassembly/Assembly of machine.
01189 Safety Lock Lever
•
A 57375 Valve Stem must be used in
conjunction with this lever to function
properly.
95542 Grease 10 oz.
•
Multi-purpose grease for all types of bearings, cams, gears.
•
High film strength; excellent resistance to water, steam, etc.
•
Workable range 0˚ F to 300˚ F.
95541 Push-type Grease Gun
•
One-hand operation.
Buy parts on line at https://Dynashop.co.uk/ for all things Dynabrade
Buy parts on line at https://Dynashop.co.uk/ for all things Dynabrade
