SETTING UP (CONTINUED)
ADJUSTING THE BURNER
Allow sufficient air to obtain a clean looking flame by loosening the lock screws and moving the air shutter, and if
necessary, the bulk air band. Reduce the air supply until the flame tips appear slightly smoky, then increase the
air just enough to cause the flame tips to appear absolutely clean.
DRAFT CONTROL ADJUSTMENTS
The unit is set up in the factory to burn cleanly into atmospheric conditions. Therefore if a chimney is fitted to the
machine, an "O" draft would be the optimum condition.
FINAL AIR-ADJUSTMENTS
Allow at least ten minutes for warm-up, and longer if the unit is new, in order to burn off the oil deposits on the
heat exchanger and other surfaces. Check and adjust all controls. (See Manufacturer’s Instructions sheets.) Test
the primary control Safety Switch to insure a safety shutdown will occur in the event of equipment malfunction
NOTE
- These settings have already been completed for the machine and only apply if a new burner or coil is
installed.
OPERATION
STARTING THE MACHINE
1. Make sure all switches are in the "OFF" position.
2. Connect the electrical supply cable. (Plug the unit into the electrical receptacle.)
3. In "SETTING UP INSTRUCTIONS" you have already been asked to connect the unit to the water supply.
Turn on the water.
4. Pick up the spray gun and hold it firmly, and pull the trigger to evacuate all air in the system. Release gun
trigger.
5. Now turn Pump Switch to "ON". The pumping unit will start.
6. Hold the spray gun firmly and squeeze the trigger on the gun, and when the spray is constant, turn the
Burner Switch to "ON". The oil burner will ignite. Then turn "THERMOSTAT" to the desired temperature.
CAUTION
- The force of the water leaving the nozzle causes a kickback or recoil at the trigger gun.
3
BEF
SERIES
