Hardware Used
A
M6x12 Screw
Qty: 16 pcs
B
6mm Flat Washer
Qty: 16 pcs
C
6mm Spring Washer Qty: 16 pcs
3
2
1
A
C
B
B
C
A
Step 1
:
Assemble the locking casters (2) and casters (3).
Secure the locking casters (2) with four screws each (A), four
spring washers each (C) and four flat washers each (B) to the
rear side (side with cut-outs for accessing locking mechanism)
of the cart bottom shelf (1). Tighten all screws. As illustrated,
the flat washer (B) is placed under the spring washer ( C).
Install the casters (3) to the front side (side with no cut-outs)
of the cart bottom shelf (1) using four screws (A), four spring
washers ( C) and four flat washers (B). Tighten all screws.
Step 2: Assemble the LP cylinder exclusion (28).
Using 1 screw (A) at each end of the LP cylinder exclusion (28)
attach to cart bottom shelf (1), as illustrated.
Hardware Used
A
M6x12 Screw
Qty: 2 pcs
A
1
Dual Fuel Grill
ASSEMBLY INSTRUCTIONS
28
Hardware Used
A
M6x12 Screw
Qty: 4 pcs
Step 3
:
Assemble the cart side panels (4 & 5).
Partially insert 4 screws (A) into cart bottom shelf (1), leaving a
4-6mm gap between the screw head and the top surface of the
cart bottom shelf (1). Each cart side panel (4 & 5) has 2 key-
holes located on the bottom of each panel. Using the keyholes,
place the cart side left panel (4) over the screws just inserted in
the cart bottom shelf (1) and slide the cart left side panel forward.
Secure the panel by hand tightening the screws, but do not fully
tighten the screws until after Step 4 (to allow for readjustment
once all the panels are assembled.) Attach the cart right side
panel (5) to the cart bottom shelf (1) following the same steps.
1
2
3
9
4
5
1
A
1
A
4
NOTE: Use caution when assembling and operating this unit to avoid cuts and scrapes from edges.
