www.dymondusa.com
need setting to 120
Are You Ready! We are go to flying now!
-
Open the radio controller then connect battery to HiBiRD. Orange LED will solid and Blue LED will slow flash
-
Next step we need to Setup GYRO balance and unlock first. (Gyro balance setting need to setup every time before
flying HiBiRD and please keep HiBird keep balance no vibration)
-
Balance Gyro by move joystick ELEV to bottom position and move joystick THRO to bottom and move joystick
RUDD to bottom postion .Blue LED will keep to close
（
for both DSM2and DMSS
）
. follow by photo below.
*** Please note : Not still handle HiBiRD in hand because setting gyro balance process will not
success.
-
Next Step is UNLOCK motor by move joystick THRO to bottom and RUDDER to left position (for
both DSM2 and DMSS) the Blue LED will solid on, This is Already to Fly !!!
-
If we need LOCK motor to not working.Please move joystick THRO to bottom and RUDDER to right position. the
Blue LED will close , This is LOCKING mode.
Radio 6 channel at have AUX1 Function can be setting sensitive for control the
HiBiRD
1.
AUX1 in High Position channel Aile/Elev/Rudd will be to High Sensitive hand adjustment mode
2.
AUX1 in Middle Position channel Aile/Elev/Rudd will be to High Sensitive Auto-adjustment mode
3.
AUX1 in Low Position channel Aile/Elev/Rudd will be to Low Sensitive Auto-adjustment (for Beginner
player)
4.
AUX1 Sensitive mode Function can adjusting when flying.
CAUTION :
HiBiRD have Failsafe system works during flying if radio close or signal lost the
Motor will slow down automatically and 8seconds later the motor will stop and land safely.
Please make sure the 4 Screw in flight controller be tight enough to make sure the body
keep balance and stable. Please adjust the Screw to make sure the Motor feet in horizon level and
make the Quad balance.
Charging Battery HiBiRD
We can be used Charger board connect to Computer PC USB Port
or use Charger Adaptor 5V of Mobile Phone. Battery charging mode LED will solid on. When
battery full charge LED will off.
Charger Specifications:
Input Voltage : 5V
Current : 500MA
Output: 3.7V Single LIPO
Red Wire is (+) , Black wire is (–)
