10
U S E R G U I D E
|
U V C S S I D E CU R E C O N V E Y O R
Figure 6.
Upper Lamp Support Housing with Two Lamps
–
Three Possible Configurations
8.
Install the Lamp/Reflector Housing Assemblies onto the Lamp Support Brackets on the front and rear side of the
Conveyor (Figure 7). Install the Light Shields over each Lamp Support Bracket (Figure 8). Adjust the Lamp position
as desired and then tighten the two Lamp Securing Knobs.
Figure 7.
Reflector Installed in Lamp Support Bracket
Figure 8.
Lamp Support Bracket with Light Shields
9.
Attach the Connector Cable leading from each Reflector to the rear of each Power Supply (Figure 9). Connect the
Conveyor’s Power Cord to a 120 Volt AC power source (230V AC
for 230-
Volt units). Connect each Power Supply’s
Power Cord to a 95-260 Volt AC power source.
Figure 9.
Power Supply, Rear Panel
Figure 10.
Speed Controller Knob
10.
Turn the Conveyor on by means of the Power Switch.
Securing Knobs
