11
Dymax EC-Series Flood Lamps User Guide
System Interconnection
Figure 5. Interconnection Diagram
#
Part Description
#
Pat Description
1
Shutter, Optional
5
Shutter Interconnect Cable, Optional
2
Power Supply (8-Pin Connector)
6
Plug, Adapter, Optional
3
Reflector (8-Pin Connector)
7
Foot Pedal, Optional
4
8-Pin to 8-Pin Interconnect Cable
1.
Place the 400 Watt Bulb into the Lamp/Reflector Assembly Housing. Refer to the Bulb Replacement/
Installation section of this manual.
2.
A Glass UV Filter is available as an option. This Glass UV Filter reduces heat produced by Lamp but will
also reduce UV output of Reflector. To install the optional Glass UV Filter (sold only for the 2000-EC
Flood Lamp):
NOTICE:
It is important to wear protective gloves when installing the Glass UV Filter! Do not touch the
Filter with bare fingers! Fingerprints may etch into glass and cause light transmission loss!
■
Place the Reflector Housing upside down on a flat surface.
■
Loosen the four screws in the bracket that hold the Reflector to the Housing.
■
Slide the Glass UV Filter under the brackets and adjust it symmetrically over the Reflector
Aperture.
■
Tighten the four screws.
