Dyaco FT98A-YT41, Руководство по обслуживанию

Страница: 72 / 90

S S e e r r v v i i c c e e M M a a n n u u a a l l
71
Treadmill will only achieve approximately This indicates motor should be receiving power to operate. Low AC voltage to treadmill. Do not use an extension cord.
10 kph but shows higher speed on display If an extension cord is required it should be as short as possible and heavy duty 16 AWG minimum. Low household voltage.
Contact an electrician or your dealer. A minimum of 110 volt AC current, 60 hz is required.
Treadmill trips on board 15 amp circuit High belt/deck friction. See General Maintenance section on Belt/Deck Lubrication..
Computer shuts off when console is Treadmill may not be grounded. Static electricity is “crashing” the computer. Refer to section 7.3 for Grounding Instructions.
touched (on a cold day) while walking/running
House circuit breaker trips, but not the Need to replace the house breaker with a “High inrush current” type breaker (see section 7.2 for Important Electrical
treadmill circuit breaker. Instructions.)
Treadmill with noises
1. If the noise is coming from the rollers
, .
2. If the noise is coming when the user is running on the treadmill with lowest level of incline
,
it could be due to too much
pressure with the incline cylinder. (only in case of the lowest incline level).
3. If there is knocking noise during the workout, check and make sure all bolts are tightened.
4. When there is thumping noise while the belt is running. This happens with a brand new treadmill or when the treadmill has
not been used for a long time. This is due to the belt has been shaped with rollers and harden because of low temperature.
Running the belt for tens of minutes the thumping noise will gradually go away.
Noise under motor cover.
1. Worn brushes or bearings on motor. Replace with new motor brushes.
2. Front roller bearings are defective. Replace with new front roller.
3. Drive belt is misadjusted (too tight or too loose). Adjust motor position.
Noise in the rear of the treadmill.
1. Rear roller bearings are defective. Replace with new rear roller
2. Rear roller misaligned. Adjust rear roller position.
Tread belt hesitates while being
1. Insufficient lubricant on tread belt.
stepped on.
2. Tread belt tension insufficient
Black particles collecting under
Drive belt is breaking in. Vacuum under treadmill periodically.
treadmill.