DXV Percy D35105870, Руководство по установке

Страница: 3 / 8

- 3 -
M965534 Rev. 1.9 (4/18)
4
5
6
8
7
INSTALL POP-UP DRAIN TEE ASSEMBLY
REMOVE MOUNTING WASHERS
AND LOCKNUT
ATTACH DRAIN FROM
BELOW FIXTURE
FLANGE GASKET AND POP-UP KNOB
TIGHTEN LOCKNUT
• Remove CLEAR PLASTIC COVER
(1)
.
Fig. A.
• Remove FOAM SPACER
(2)
from under
DRAIN POP-UP (3) . Fig. A.
• Tighten TAILPIECE (4) on DRAIN BODY before
installing DRAIN BODY.
Fig. B.
• Thread LOCKNUT (1) counter-clockwise and
remove from drain body. Remove PLASTIC
WASHER
(2) and pull off RUBBER CONE
WASHER
(3)
.
Fig. A.
• Drop DRAIN BODY
(4)
through sink drain hole.
Make sure WHITE FOAM GASKET (5) is under
flange of DRAIN BODY
(4)
.
Fig. B.
Note: No plumber’s putty or caulk is required.
• The CABLE ATTACHMENT POINT
(6)
mustface
towards the rear of the SINK. Fig. B.
• From under side of SINK install
RUBBER CONE WASHER (3) ,
PLASTIC WASHER
(2)
and
LOCKNUT (1) onto DRAIN
BODY
(4)
.
N ote: The CABLE ATTACHMENT
POINT (5) must face
towards the rear of
the SINK.
• Check DRAIN FLANGE in SINK to ensure that
WHITE FOAM GASKET (3) is fully compressed
and not visible.
Fig. A
.
• POP-UP KNOB
(1)
must be fully down.
Fig. B.
• Tighten LOCKNUT (1) firmly with
Adjustable Wrench or Channel Locks.
2
3
1
DRAIN
BODY
4
Fig. A. Fig. B.
Fig. B.
REAR OF
SINK
4
5
6
SINK
DRAIN
HOLE
1
3
2
Fig. A. Fig. B.
WHITE FOAM
GASKET
NOT VISIBLE
DRAIN
FLANGE
UP
1
DOWN
Fig. A.
Fig. B.
1
5
3
2
4
1