- 2 -
7302268-100 Rev. A (8/17)
DRAWER INSTALLATION
• Studded walls must be exposed for installation of brackets.
• Provide suitable 2x8 horizontal brace at least 36" long, notched and
flush to exposed studs where the drawer will be mounted.
Figure 1.
NOTE:
Remove bracket mounting screws to remove brackets from drawer.
• Brackets must be spaced at 34-1/2" apart on the 2x8 horizontal brace
and level. Mark these hole locations on the 2x8.
Figure 2.
• Drill 3-32" pilot holes for each of the holes where the 1/4 x 1-1/2"
Lag Screws will go.
• Install each bracket using the 1/4 x 1-1/2" Lag Screws ensuring the
brackets are level and at the required 34-1/2" distance from each other.
• Finish covering the wall with waterproof drywall.
Do not cover the brackets mounting base area.
• Unpack unit carefully, taking care not to damage the corners, unit is heavy.
• Remove the drawer from the cabinet by rotating the plastic clips underneath
the drawer rails, then pull drawer off the rails.
• Place the cabinet section of the drawer into the mounting brackets and
ensure the cabinet sits flush against the surface of the wall.
• Drill a 1/8" pilot hole through each of the brackets holes into
the wooden cabinet.
CAUTION: DO NOT DRILL THROUGH THE SIDE OF THE CABINET!
• Use a #10 x 1-3/4" wood (preferably MDF) screws to attach the cabinet
to the bracket.
• Place the drawer back onto the cabinet rails and latch the plastic clips back
into place to secure the drawer to the cabinet rails.
Figure 1.
Figure 2.
2x8 BRACE
34-1/2" D.
BRACKETS
34-1/2"
(876 mm)
