background image

- 4 -

In the United States:

DXV

One Centennial Avenue 

Piscataway, New Jersey 08855

Attention: Director of Customer Care

For residents of the United States, warranty 

information may also be obtained by calling 

the following toll free number: (800) 227-2734

www.DXV.com

In Canada:

DXV 

5900 Avebury Road  

Mississauga, Ontario  

L5R 3M3 

Canada

Toll Free: 1-800-387-0369

Local: 905-306-1093 

Fax: 1-800-395-1498 

www.DXV.ca

In Mexico:

DXV 

Via Morelos 330 

Col. Santa Clara Coatitla  

Ecatepec, Estado de México 55540

Toll Free: 01-800-8391200

www.DXV.mx

770283-100 (2/2020)

10

Align slots in metal console with holes in marble side panel using a small flashlight to visually see where the hole locations are,  
position the marble side panel 

(5 or 6)

 with that of the slots on the metal console frame. Place a washer over one of the  

supplied 10-32 x 1

"

 screws and place through the slot of the metal console into one of the screw holes of the marble  

side panel 

(5 or 6)

. 4 screws are required for each marble panel. Ensure rear of side marble panel 

(5 or 6) 

is flush to rear  

of marble top

 (4)

. Tighten in place. 

Do not over tighten!

 Once side marble panel 

(5 & 6)

 are installed to marble top 

(4)

,  

check to determine if the side panels are approximately at the same level as the top surface of the marble top.  
Slight adjustment to the side marble panels can be made to accomplish this.

Install faucet and drain to sink according to manufacturer’s instructions.

Complete installation of drain and water supply lines per manufacturer’s instructions.

Position completed assembly upright against the wall over drain and water supply lines. Level marble top front to back and  
side to side. Adjust level using adjustable feet on the bottom of metal console frame legs 

(1 & 2)

. Pre-drill 2 pilot holes in  

the rear of the wooden marble top and screw marble top to wall into cross support or stud behind finished wall using  
#10 x 2

"

 wood screws (NOT SUPPLIED) to securely attach console to wall. 

NOTE:

 

The console must be fully attached to the wall.

After the drain and water supply lines have been connected and checked for leaks, carefully place the glass shelf

 (7)

  

onto the shelf support studs on the lower portion of the console assembly. 

11

13

12

14

9

Position metal console rear side flush to the rear of the marble top 

(4)

.  

Using supplied #10x2" wood screws and washers, screw console  
frame to wooden portion of marble top 

(4)

 following predrilled pilot  

holes.

 

4 screws are required for each side. Slots are provided in  

the frame for alignment of frame to rear of marble. 

Tighten into place.

Содержание Belshire D19080000.550

Страница 1: ...00 550 Marble Top Console No Hole D19080003 550 Marble Top Console Three Hole D21065000 144 Console Frame Platinum Nickel D21065000 427 Console Frame Satin Brass D20205000 415 Undercounter Lavatory DXV Belshire Console Lavatory Kit 770283 100 2 2020 Product names listed herein are trademarks of AS America Inc AS America Inc 2020 Adjustable Wrench Regular Screwdriver Phillips Screwdriver 10 Putty K...

Страница 2: ...ind the console must be reinforced to provide secure mounting for the new unit Preparing Wall for Console Mounting 1 Remove wallboard covering from designated area 2 Toenail 2 x 6 51 x 152 mm cross piece between studs or notch studs to accept a 1 x 6 25 x 152 mm crosspiece and attach securely Place the console into desired position and check height for dimensional location of horizontal crosspiece...

Страница 3: ...ternately do not overtighten Clean off any sealant that may have run out Place assembled metal console frame 1 2 3 upside down over marble top 4 and lavatory ensuring rear of console is positioned to the rear of the marble top The rear of the metal console frame can be identified by a slight opening on the top of the console frames tubing this is the rear Refer to section 2 7 Ensure marble top and...

Страница 4: ...determine if the side panels are approximately at the same level as the top surface of the marble top Slight adjustment to the side marble panels can be made to accomplish this Install faucet and drain to sink according to manufacturer s instructions Complete installation of drain and water supply lines per manufacturer s instructions Position completed assembly upright against the wall over drain...

Отзывы: