16
Control and Power Connections
If you have the
DXE-RFS-SYS-4S
system, with the
DXE-EC-4
Control Console, no other
equipment is needed for powering the
DXE-RFS-SYS-4S
, the active elements or controlling the
receive direction of the
DXE-RFS-SYS-4S
. The
DXE-RFS-SYS-4S
has been factory-set to work
with the
DXE-EC-4
using four conductor control cable such as
COM-CW4
.
J12
is the 5-terminal connector plug on the front panel of the
DXE-RFS-3
. It is labeled
G A B C G
.
The
DXE-RFS-3
uses a two part green connector and the top part can be removed by pulling it
straight off. This will allow easier wire replacement or servicing as needed. When pushing the
connector back in place, ensure you press straight inward.
The
DXE-EC4
uses an internal terminal plug labeled “G 1 2 3”.
DXE-EC-4
DXE-RFS-3
G
to
G
1
to
A
2
to
B
3
to
C
Direct Wire connections between the DXE-EC-4 and DXE-RFS-3
For systems that have 1/2-wavelength or greater spacing between the receive four square array and
any transmitting antenna, The optional
TVSU-1B
may not be needed. The wiring diagram above
