22
DXE-CPT-659 - Coax Cable Stripper for CATV F-6, RG-6 and RG-59 coax
Prepares CATV F-6, RG-6 and RG-59 coax cable for the installation of an "F" type connector.
One-step cutting motion
Precision cut
No nicks or scratches to conductor
Includes 1 replacement blade
DXE-SNS6-25 - Watertight Coax Connector, Snap-N-Seal for CATV F-6 Cable, 25 pieces
Snap-N-Seal is an environmentally sealed CATV F coax connector system for harsh environments. The connectors have a unique,
360 degree radial compression system that offers the signal leakage protection required for high performance receive systems.
Quad sealed system prevents moisture from migrating into the connection
360 degree radial compression provides superior RF integrity (-95 dB typical, 60% bonded foil cable)
Easy cable preparation
Connector to cable retention of 40 lbs minimum
Superb impedance match to 1 GHz
Manufactured of high quality 360 brass, cadmium plated with yellow chromate coating for maximum corrosion resistance
UV-resistant plastic and O-rings provide a reliable environmentally sealed connector
An installation tool, such as the
DXE-SNS-CT1
, is required to install the connectors. Normal crimping tools or pliers will not work.
DXE-SNS-CT1 - Compression Tool for Snap-N-Seal 75 Ω Coax Connectors
Ratchet compression tool for installing Snap-N-Seal 75 Ω Coax connectors. Ordinary pliers will not install these
connectors properly.
COM-CW4 - Cable, 4 Conductor, Sold per Foot
A high quality, PVC jacketed 4-wire control cable, COM-CW4 consists of 4 #20 AWG conductors. It may be
used in a multitude of control cable applications, such as remote switching and antenna rotators.
Sold by the foot - order the length you need.
DXE-ARAV3-4P - Receive Antenna Active Vertical w/Relay Pkg. of 4
The
DXE-ARAV3-4P
Active Receive Antenna array package contains 4 of the
Active Receive Antennas. This
package is intended for use with the
Receive Four-Square system to build a Four-Square Receiving Array. The FVI-1
Feedline Voltage Injectors are not included as the RFS-3 has provision for powering the
active antennas.
The ARAV3-4P Vertical Array System package Includes:
Four Active Antenna Verticals, for use with the DX Engineering
Receive Four Square system.
DX Engineering’s Active Receive Antenna system offers excellent receiving performance
from 100 kHz to 30 MHz using a whip antenna element 102 in. long. DX Engineering’s
unique design makes it vastly superior to traditional active antennas in both strong signal
handling and feedline decoupling. You get significantly better weak signal reception due
to lower spurious signal interference and reduced noise. This antenna system is ideal for Amateur Radio or Shortwave Listening.
The
ARAV3-4P
active antenna grounds the antenna element when power is turned off. This active antenna is used in installations
with spacing from transmit antennas less than 1/2 wavelength but more than 1/10 wavelength (on the lowest frequency). Sites with no
room for proper spacing should use the ARAV3-4P, which can be installed in close proximity to transmitting antennas (1/10-
wavelength of the lowest transmitting frequency), provided the unit is powered off at least 5 ms before transmitting. A sequencer
such as the
should be used to ensure the correct transmit to receive switching. The
can provide the power for the active antenna and the proper transmit power-off sequencing.
