- 16 -
Note:
As you raise the antenna to the
vertical position, it’s important to
also maintain the parallel
alignment between the antenna
mounting channel and the Tilt
Base backing plate to minimize
binding. Make sure the lower tilt-
base bolts are never excessively
loose before raising or lowering.
They should be first tightened
securely and then backed off no
more than 1/2 turn.
Once the antenna is fully raised, tighten the tilt base hardware (Top: two Nyloc nuts and two flange
nuts, Bottom: two Nyloc nuts.)
Feedline Connection
Install the
DXE-1023
Bulkhead Type-N Connector into the
DXE-RADP-3
Radial Plate as shown in
Figure 12
. Use the
supplied Hex Nut and External Tooth Washer.
Figure 12 - Bulkhead Connector
Installed in Radial Plate
Install the
DXE-FP-WIRE-N
Type N Feedpont Connection assembly with Wire and Ring
Terminal to the antenna Feedpoint and the previsously installed bulkhead connector as shown in
Figure 13
.
Figure 13 -
DXE-FP-Wire-N
installed
