- 11 -
Place a flat washer and a spacer on each of the hex head bolts.
The bottom antenna element has
larger holes on one side, these larger
holes face the spacers.
The bottom
antenna element is installed so the spacers
are
inside
of the element. Refer to
Figures
3
,
4, 5
and
Figure 6
for details.
On the bottom hex head bolt, install an
external tooth washer, one of the wires with
a ring terminal, followed by a flat washer,
split washer and a hex nut as shown in
Figure 5
. Note the direction of the wire in
the photo. On the top hex head bolt, install
a flat washer, split washer and a hex nut.
Tighten in place.
Figure 6
The other end of the wire has a fork lug, is connected to the
ANT+
on the AVA2 as shown in
Figure 7
between the two flat washers. Tighten in place.
Figure 7
NOTE:
The following describes the use of the
DXE-SSVC-1P
and
DXE-SSVC-1PG
Clamps that
are included with the
ARAV4
. These are used for mounting the
ARAV4
on a typical
ground rod from 1/2" OD to 3/4" OD.
If you plan to mount the
ARAV4
to a larger mounting mast, you will need two optional
DXE-SSVC-150P
and one optional
DXE-SSVC-150PG
V-Clamps which will
accommodate a mounting mast that is 1" OD to 1-1/2" OD.
