1
1.
SAFETY MEASURES
Before starting the pump, read this instruction booklet carefully and keep it in a safe place
for future reference.
For safety reasons, the pump must not be used by anyone who has not read these instructions.
The pump must not be used by anyone under 16 years of age or by anyone who has not read
and understood the present instruction booklet. Keep children well away from the pump when
in operation..
The power cord or floating switch must never be used to carry or move the pump.
Always use the pump’s handle.
When handling the pump, while it is connected to the electric power supply, you should avoid
all contact with water.
Never remove the plug by pulling on the power cord.
Before taking any action on the pump, always remove the plug from the power socket.
There should be no individuals present in the liquid that is being pumped while the pump is in
use.
If the power supply cord has been damaged, it must be replaced by the manufacturer or his
authorized customer support service in order to avoid all risks.
The pump is equipped with a thermal overload safety device. In the event of any overheating of
the motor, this device automatically switches off the pump. The cooling time is roughly 15 to 20
minutes, then the pump automatically comes on again. If the overload cutout is tripped, it is
essential to identify and deal with the cause of the overheating. See Troubleshooting.
2.
USE
Multi-purpose Submersible pumps for drainage and garden ponds to create waterfalls and
fountains
The pumps are designed to pump clean water or water containing solids with a diameter up to
1/4 “
The temperature of the fluid being pumped must never exceed 95°F
The pump must not be used to pump salt water, sewage, flammable, corrosive or explosive
liquids (e.g. petroleum oil, petrol, and thinners), grease, oils or foodstuffs.
Comply with the rules and regulations of the local water authority when using the pump for the
supply of domestic water.
3.
STARTING THE PUMP
Given the different provisions applicable to the safety of electric systems in different countries,
make sure that the pump system, as concerns its intended use, is in accordance with current
legislation.
Before starting the pump, make sure that:
•
The voltage and frequency specified on the pump’s nameplate coincide with those of the
available power supply;
•
there are no signs of damage to the pump or its power cord;
•
The electric connection is made in a dry place, protected against any risk of flooding;
•
The electric system is complete with a residual current circuit-breaker GFI Ground fault Indicator
(30 mA) and an efficient earthing connection;
