27
3.12.2 VIEW ANGLE SETUP
VIEW ANGLE SETUP
PANNING RANGE
FLIP : 90
°
TILT ANGLE LIMIT : 07
°
SAVE AND EXIT(ESC TO CANCEL)
FLIP
OFF, AUTO, 90
°
, 100
°
, 110
°
, 120
°
OFF:
The PTZ camera moves until 90
°
vertically.
AUTO:
When the camera reaches the floor directly above the moving
object, it will stop. At that time, release the controller instantly
and pull it down again to run the auto-flip function. When you
use the panning range, it is recommended to use the flip mode
to AUTO.
90
°
, 100
°
, 110
°
, 120
°
: Allows the image to flip digitally when the camera moves over
the setting angle vertically.
TILT ANGLE LIMIT
-10
°
~ 10
°
This option is designed to limit the view angle as there is some
obstruction in zooming out on specific areas of the tilt angle.
NOTE: Focus issues may occur in certain conditions.
PANNING RANGE
When the camera is installed near a wall, the panning range
can be limited by the user.
PANNING RANGE SETUP
(CTRL KEY)
RIGHT LIMIT : 000.0
LEFT LIMIT : 000.0
ENABLE : OFF
SWAP : OFF
AUTO PAN : ON
SAVE AND EXIT(ESC TO CANCEL)
1.
Place the PTZ camera under 90 degrees vertically.
2.
Set the “RIGHT LIMIT” by pressing the Right key.
3.
Set “LEFT LIMIT” by pressing the Left key.
4.
Set “ENABLE” to ON to use.
To exchange the right and the left limit, set “SWAP” to ON.
To apply limits on the auto pan (endless panning), set “AUTO PAN” to ON.
NOTE: When the flip mode is at 90
°
, 100
°
, 110
°
or 120
°
and you move the camera
over 90
°
vertically, the panning range operates on the opposite side.