DVTEL ioimage trk100, Руководство по установке

Страница: 19 / 37

Installing and Connecting the Unit
9
3 Installing and Connecting the Unit
This section describes how to install and connect the unit and includes the following sections:

Installing the Unit (page 9 )

Connecting the Unit (page 9 )

Resetting the Unit (page 17)
Note:
After connecting the unit, proceed to configure the unit as described in the HTML Edition
Units User’s Guide .
3.1 Installing the Unit
The unit can be installed inside an equipment room on a regular shelf or in a rack. When installing the unit,
make sure that:

It is securely tied down and cannot be easily dislodged

Operating temperatures are kept between the minimum/maximum allowed at all times

Proper ventilation is provided so that the air is free to circulate around the unit

The unit is protected from direct weather conditions (for example, sunlight, rain, dust, etc.)
Caution:
To avoid damage from overheating or unit failure, ensure that there is sufficient
temperature regulation to support the unit’s cooling/heating requirements. Ambient
operating temperature should be kept within 0°to 50°C (32° to 122°F), with no more than
95% non-condensing humidity.
3.2 Connecting the Unit
This section describes the procedures for connecting the unit and includes the following sub-sections:

Grounding the Unit (page 10)

Connecting the Unit to the Power Supply (page 10)

Connecting the Unit to the Network (page 11)

Connecting the Video Source (Camera) to the Unit (page 12)

Connecting a Microphone to the Unit (page 13)

Connecting a Loudspeaker to the Unit (page 14

Connecting PTZ Camera Controller Lines (page 14)

Connecting the Analog Video Output to an Analog Device (page 15)

Connecting the Unit to Receive Alarms from External Devices (Alarm Inputs) (page 15)

Connecting the Unit to Control an External Device (Using Relay Outputs) (page 16)