DVS SDStationOEM, Руководство по установке

Страница: 16 / 46

1-6
SDStationOEM Installation Guide
Declarations of Conformity
This product was tested according to the applying direc-
tives and regulations of the EC and the FCC. Further in-
formation on this can be found in section “Conformity
Declarations” on page A-4.
Unplugging Cables
If you want to unplug one of the flat cables after its installation on the
board, please observe the following:
Flat cable connectors are equipped with a locking mechanism to pre-
vent them from becoming disconnected after they were plugged in.
To unplug the connector use your index finger and thumb to press the
locking wings together.
Figure 1-1: Unplugging flat cables
Then you can easily remove the connector.
Don’t use any force to disconnect flat cable plugs, otherwise
the socket on the board may be damaged or even break off.