DVS Atomix LT, Руководство по установке

Страница: 38 / 72

3-4
Atomix LT Installation Guide
Jumper Settings of the Audio Panel(s)
On the audio panel that should be installed as the audio panel #1 (see
section “Note About the Audio Setup” on page 2-10) up to four stereo
channels of AES/EBU or three stereo channels of AES/EBU and one LTC
in- and output can be transmitted. This signal configuration has to be
configured via jumper settings on the printed circuit board mounted to
the audio slot panel.

Before installing the audio panel #1 please check whether the jump-
ers on the printed circuit board are set to your desired configuration
and, if appropriate, adjust them:
Figure 3-2: Jumper settings for audio (audio panel #1)

If available, check the jumper settings of the audio panel that
should be installed as the audio panel #2. They should be set as the
indicated in the left drawing (figure above, 4th audio channel acti-
vated).
After checking and, if appropriate, adjusting the jumpers of the audio
panels to their correct settings you can go on with the next step and
install the board into the computer system.
3.1.2 Installation of the Board
With the second step the Atomix LT board will be installed in the pre-
pared computer system. For this perform the following:
LTC activated
4th audio
channel activated