DVS Atomix LT, Руководство по установке

Страница: 25 / 72

2-7
Overview
2
1
3
I
4
A
Figure 2-4: Items on the Atomix LT board’s soldering side
2.2.4 Digital Video I/Os of the Atomix LT Board
This section contains some information about the digital video in- and
outputs of Atomix LT.
DVS usually names the input/output channels (connectors/ports) of
the digital video signals alphabetically: the main video stream is then
available, for instance, on port A and the secondary video stream on
port B. For YUV you normally require one link (connectors named ’A’,
Item Explanation
DIP switch for Flash
controller Controls the operation of the on-board Flash
controller. It determines whether the main or
the fallback map will be loaded at startup (see
also chapter “Maintenance” on page 4-1).
Default/factory setting of the DIP
switch for the Flash controller (main
map). Please observe the orientation
of the switch on the board.
For normal operations the default
setting has to be used.
LEDs Indicate that the programmable chips (FPGAs)
are programmed. If both are illuminated, the
firmware is programmed and the board will op-
erate properly. If even one is extinguished, you
have to perform a firmware programming/up-
date (see section “Upgrading the Firmware” on
page 3-15).
DIP switch LEDs