TYPE 5320
I
NSTALLATION,
O
PERATION
AND
M
AINTENANCE MANUAL
I O M . U K . D V C . 5 3 2 0 . 3 0 0 6 1 5 - R E V . B
PAGE 4
2.
Product identification
2.1
Marking
The limit switch box name plate is located on the top cover casing. The name plate contains the
following:
Logo
Type number
Enclosure
Rated current
Accreditations, certifications
2.2
Initial inspection
When you receive the limit switch box, please make sure that the specifications of the limit switch
box (name plate) confirms with the customer order sheet and / or the required specifications.
Remove the packing wrap or carton box carefully. Inspect the product for any physical
damage that may have occurred during shipment or handling.
Check the product specification with your order. If something does not match the
requirements / differs from the expected, please contact us immediately for required
actions to be carried out.
2.3
Storage
Limit switch boxes must be stored in a clean, cool and dry area. The unit shall be stored with cover
installed and the conduit entries sealed. Storage must be off the floor, covered with a sealed dust
protector.
If limit switch boxes are to be stored outside before use / installation they must be stored off the
ground, high enough to prevent them from being immersed into water or covered with snow.
The conduit entries shall remain sealed until mounting of the power cable / signal cable takes
place.
