Instruction (English)
Blue electric worklight
Please read the following instructions before taking the lamp into use and save it for later use. The manual can also be down-
loaded from www.dva.dk.
Important:
1) Do not use the work lamp if you suspect it is damaged.
3) The work lamp may only be used at an ambient temperature of -10 C - 45 C.
4) Do not clean the working lamp with solvents.
5) Store the lamp in a clean and dry area when not in use.
5) Maximum connection length: 50 meters
6) Do not turn on the Flex-line until the entire LED strip is rolled out.
If the product breaks or the cable needs to be replaced or replaced for any other reason, contact an authorized electrician for
this. Proof of authorized work may be required for complaints where the product is not in original condition.
Note about disposal of this product:
Electrical and electronic equipment (EEE) contains materials, components and substances that may
be dangerousand harmful to human health and the environment when waste electrical and electronic
equipment (WEEE) not disposed of properly. Products marked with the following crossed “bin” are
electrical and electronic equipment. The crossed trash symbolizes the waste of electrical and
electronic equipment must not be disposed of with unsorted household waste but must be collected
separate. To this end, all municipalities have established collection systems where waste electrical and
Electronic equipment free of charge can be handed over by citizens at recycling stations or other collection sites or retrieved
directly from households. Further information should be obtained from the municipality’s technical management. Users of elec-
trical and electronic equipment must not dispose of waste electrical and electronic equipment together with household waste.
Users should use the municipal collection systems to reduce the environmental impact of waste disposal of electrical and elec-
tronic equipment and increase the possibilities for recycling, recycling and recovery of waste electrical and electronic equipment.
Instruktion:
On and off
The Flex-line is switched on by plugging the power plug into a power source. The Flex-line is switched off by disconnecting the
power source. There is no on/off switch on the LED strip or reel itself.
LED strip interconnection
1) Check where + and - are indicated in the connectors. The poles must meet when the connectors are assembled. Note the
direction marking
at the edge of the connector.
2) Gently press together the male and female part. The plugs should be easily compressed.
3) Use the screw to lock the 2 connectors together.
This product is CE certified in accordance with applicable EN standards for this type of lamp.
The product has been tested and approved according to
EN60598-1, EN60598-2-4, EN62471, EN62493, EN61547,
EN55015, EN61000-3-2, EN61000-3-3.
The light source in this luminaire may only be replaced by the manufacturer, the importer DVA A/S servicecenter or
by a correspondingly qualified person. (EN60598-1:2015 § 3.2.24, §3.2.24, §3.3.21 og §4.30.)
2
1
3
