DV Systems HTD AL 18, Инструкция по эксплуатации и техническому обслуживанию

Страница: 13 / 44

ENGLISH
Cod. 710.0134.20.00 Rev06B
– 04.2016
11
Pic.4 drain solenoid valve
When it is necessary:

Clean the mesh filter of the
condensate drainage system

Clean the filter mesh
4.3 DISMANTLING
All work on the dryer may only be carried out by specialist personnel!
Follow this procedure if you need to shut down the dryer:

Stop the device and permanently isolate it from the electricity mains;

Disconnect the power cable;

Take pressure off the air circuit;

Empty the tank and the internal cooling medium circuits;

If the device has to be dispatched, use the original or similar packaging and keep the device in an up-
right position.
Before carrying out any work on the electrical parts, make sure that the main switch interrupts the electricity
supply to the dryer and then affix appropriate warning signs to avoid the machine being reconnected to the
electricity mains!
Please consult the contents and the safety instructions in the relevant sections of these instructions for details
of the correct handling and storage of the chiller. Remove any residual cooling medium from the dryer in a
manner appropriate to its properties and in accordance with the legislation in force.
If the device has to be demolished: Never open the sealed cooling assembly (compressor, evaporator and
condenser) if there may be any refrigerant or lubricating oil present!
Send the chiller to an approved waste disposal company in accordance with current environmental protection
legislation. The other materials/waste constituents must be treated in line with the provisions of the valid
legislation.
Cleaning of the drain solenoid valve
Filter mesh