© DV Signage 2012
Page 6 of 14
3
NETCFG.INI and DVSYNC.INI setup
To enable video synchronization feature on VS-700, a special options are required to setup in
NETCFG.INI file. Below is the section to show how to configure a NETCFG.INI for master unit
and slave unit respectively.
3.1 Configure a NETCFG.INI for master unit
Copy all video content on to “media” folder on USB flash drive.
Create a NETCFG.INI and place it in the “media” folder on the USB flash drive.
Update the video content and NETCFG.INI on to the Master unit (VS-700) through
USB update
. (see VS-700 user guide)
The NETCFG.INI file contains some system and network settings. The following table
shows the major options required in Video synchronization.
Options in NETCFG.INI
Description
IP_OVERWRITE
0 – Keep old IP address
1 – Use the new IP address
IP
IP address
NETMASK
Subnet Mask Address
GATEWAY
Gateway address
DNS1
DNS1 address
DNS2
DNS2 address
NETSYNC_MASTER_MODE
Master mode enable
(0=disable, 1=enable)
NETSYNC_NUM_SLAVE
The total number of Slave unit in the
LAN.
Below is an example of a NETCFG.INI file for “Master unit”:
IP_OVERWRITE=1
IP=10.1.0.70
NETMASK=255.255.255.0
GATEWAY=10.1.0.1
NETSYNC_MASTER_MODE=1
NETSYNC_NUM_SLAVE=4
Note: All master and slave unit must in different static IP addresses.
