Manual BAC25A
M-B025CN-300-EN
20
3.3.2 UU mode
Once the parameters are set in the main manu,
ENTER
should be pressed to confirm the selection
and
Ready to charge
screen will be displayed (Figure 3-21).
Figure 3-21: The
Ready to charge
screen
Up to two enabled limits can be displayed on the
Ready to charge
screen for final, pre-test
verification. If the user needs to modify any limit settings before the charging is started,
STOP
button should be pressed to exit the
Ready to charge
screen (which will enable the
LIMITS
button).
In case limits settings are satisfactory, charging can be initiated by pressing the
START
button.
Figure 3-22: The
Charging
screen
The
Charging
screen provides information on charging voltage, charging current and duration.
Green and red LEDs flash alternately during the charging process.
If the user decides to change a charge voltage during the charging process, it can be achieved by
pressing the
MODE
button (Figure 3-23).
Figure 3-23
Once
Boost U and /
or
Float U
parameter is reset, the
ENTER
button should be pressed to display
the
Charging
menu (Figure 3-22).
Besides charging voltages, limit and alarm settings can be also reset during the charging. By
pressing
Limits
button, the
Limits
menu is displayed (Figure 3-24) enabling limit parameters reset.
Changes are confirmed by pressing
ENTER
and the display switches back to the
Charging
screen.
