2
Dux Readyhot 11.007 V2 - 28/9/11
DUX READYHOT (DEU-CUG1-AK) INSTALLATION MANUAL
You must install this appliance in accordance with these Instructions and all regulatory requirements which exist in
your area. Applicable publications may include:
•
AS/NZS 5601 - Gas Installations
•
AS/NZS 3500 - National Plumbing and Drainage
•
AS/NZS 3000 - Wiring Rules
•
Building Codes of Australia
NOTICE TO VICTORIAN CONSUMERS
This appliance must be installed by a person licensed with the Plumbing Industry Commission.
Only a licensed person will have insurance protecting their workmanship.
So make sure you use a licensed person to install this appliance and ask for your Compliance Certificate.
For further information contact the Plumbing Industry Commission on 1800 015 129.
THE READYHOT SYSTEM MUST BE MOUNTED ON A VERTICAL WALL OR STRUCTURE.
THE READYHOT SYSTEM CANNOT BE USED BY ITSELF OR WITH ANOTHER MANUFACTURERS WATER
HEATER OR WATER CONTROLLERS.
•
The Dux Readyhot system is Certified and compatible only with the Dux Endurance water heaters.
•
At least one Water Controller must be used in conjunction with the water heater and the Readyhot system.
Alternatively, if Water Controllers cannot be used a manual activation switch is available from electrical
wholesalers.
•
The installation of the water heater and water controllers must be performed in accordance with the 'Operation /
Installation manual' supplied with the water heater.
•
The Readyhot system is designed for domestic installations. However, it may be suitable for certain non
domestic installations. Contact Dux Manufacturing for more information.
READYHOT KIT CONTENTS (Fig.1)
The Dux Readyhot kit comprises an enclosure containing circulating pump, water connections for cold water inlet,
cold water outlet and heating loop return, control wiring and printed circuit board. It is fitted with an electric power
cord with three pin plug suitable for connection to a 240 V 10 Amp GPO. It is also fitted with a control lead for
connection to the Dux Endurance water heater.
A Switch Harness (U268-605) is also provided for connection to a Manual Activation Switch (if required).
The Dux Readyhot kit does not include:
•
10 AMP GPO
•
Heating loop flow and return pipework
•
Gas and water isolating valves
•
Control valves (non return valve, pressure limiting valve, expansion relief valve)
•
Plumbing Connections between the Readyhot enclosure and Dux Endurance water heater and Dux water
Controllers
Circulating Pump
Heating Loop
Return Connection
Cold Water Inlet
Connection
Cold Water Outlet
Connection
PCB
Fig.1
Pump Bleed Valve
Cold Water Inlet
Bleed Valve
Power Lead
Control Lead
& Socket
