
2
RBP1 - ’ABS’ Recess Box V1 - 11-007 8/6/11
DIMENSIONS
The Dux Endurance water heater serial and model numbers on the data plate located on the left hand
side of the appliance MUST BE copied to the sticker on the inside of the RBP1 - ‘ABS’ cover. The serial
and model numbers are required for future service work.
5. Remove the two M5 Nyloc nuts
from the fixing studs
of the insert.
6. Insert the upper mounting bracket
of the Dux Endurance
water heater into the bracket slot
located at the top of the
insert.
7. Push the appliance up until the lower mounting bracket
aligns with the fixing studs
and secure in place with the
two M5 Nyloc nuts
removed in step 5.
8. Connect the Dux Endurance water heater in accordance with
the Operation / Installation manual supplied with the water
heater.
9. An approved weatherproof electrical GPO can be fitted on
either side inside the insert in accordance with AS/NZS 3000
Wiring Rules.
10.Commission and test the water heater in accordance with the Operation / Installation manual supplied with the water
heater.
11.Attach the warning sticker that is supplied with these instructions to the front cover of the Dux Endurance water heater.
12.Install the RBP1 - ’ABS’ cover by aligning it with the RBP1 - ’ABS’ insert (the flue spigot hole is to be uppermost) and
push into place ensuring that the 4 locking clips
have engaged securely.
IMPORTANT
3
4
5
6
7
4
3
8
440
446
1086
11
8
1078
1023
69
383
APPROXIMATELY 1 metre
Width 390
H
eight 1
030
ALL MEASUREMENTS ARE IN MM UNLESS OTHERWISE STATED
Centre of noggin
13
0
Centre of noggin
13
0
15
8
12