SETUP
SUPPORT
1. Remove screws from the bottom front end
of your Makita gas saw (circled). Screws
are located between the 2 front feet.
2. Mount the front bracket for the Makita
gas saw over the two holes where you
just removed the screws. Align the
holes with the holes in the brackets and
replace the screws. Tighten down till
secure.
3. Install the rear mounting bracket to the
back end of the DustBull. On the tube of
the DustBull, remove the two screws and
magnet plate. Set the mounting bracket on
the DustBull over the two screw holes and
reinstall the screws and tighten till secure.
Magnet plate not needed. The rubber foot
of the rear bracket will rest on the bottom
side of the Makita gas saw.
4. Install the DustBull to your Makita gas
saw by lining up the holes in the bell of
the DustBull with the holes on the front
bracket. Insert the 6” bolt and then install
the included Nyloc nut on the end and
tighten down till secure.
5. Attach 2” vac hose to the back of the
DustBull.
www.dustlesstools.com
OM019_0116
Installation instructions for the Makita Gas Saw
Rear Bracket
Front Bracket
