Dustbane Power Clean 1200 XT, Инструкция по эксплуатации и частям

Страница: 4 / 28

4
ENGLISH
Set-Up / Prepare Unit for Use
IMPORTANT: Do not use on wet surfaces. Do not expose to rain. Store indoors.
• All Carpet Extractors, no matter what the time of year, are shipped with antifreeze in the solution lines. Prior to first use, fill
the tank with one quart of warm water. Attach the hose and using the hand tool wand, flush out the system by spraying the
one quart of water through the pump.
• Attach the 1-1/2 inch vacuum hose and the brass quick disconnect.
• Fill the base unit (the recovery tank must be removed) with warm water (less than 100 degrees Fahrenheit). Fill to
approximately 4 inches from the top. Pre-spray a liquid detergent made for carpet cleaning or upholstery on carpet and
agitate carpet. Next, use clean water from solution tank to extract – this procedure is highly recommended. Note: read and
mix your pre-spray solution to the dilution ratios as directed.
• Be sure to replace any filters back into the machine prior to use.
• Do not use citrus acid, buterol or harsh degreasers inside the machine.
Electrical
Plug cord(s) into 20 AMP grounded wall outlet(s). 20 AMP circuits are normally found in kitchens and bathrooms. Never remove
ground prong from the plug. If a circuit breaker trips during operation, turn machine off, reset the breaker and move the electrical
cord to a different outlet and resume operation.
Vacuum System
The extractor uses a dual vacuum motor system that provides outstanding water lift and air flow.
Vacuum Float Assembly Warning System
The float assembly on the vacuum stand pipe prevents the waste tank from overflowing the stand pipe and damaging the vacuum
motors. Motors will reach a fast, high-pitched sound alerting you when the recovery tank is about to over flow. When this happens,
immediately turn OFF the vacuum switches and empty the waste tank.
The float assembly has a filter to prevent lint and debris from entering the stand pipe. Refer to the “Maintenance” section for removal
and proper cleaning.
It is also necessary to use a defoamer to eliminate foam build-up in the recovery tank which could lead to foam/moisture
entering the vacuums and contributing to early failure of the vacuum motors.
If moisture does enter the vacuum motors, contact an authorized service center. To prevent moisture from damaging the vacuum
motors during storage, empty the recovery tank and store with the lid open.
Shutdown Procedures
When finished cleaning, turn OFF all switches.
• Disconnect the solution hose and vacuum hose from the cleaning tool. Pull the valve
trigger to release pressure from the hose before disconnecting the solution hose
from the cleaning tool.
• Disconnect the clear view in-line filter from the vacuum hoses and clean the filter as
needed.
• Disconnect the vacuum hose and solution hose from the machine.
• If water remains in the solution tank, use the short vacuum hose and vacuum the
excess water from the tank.
• Disconnect the power cords from the outlets and from the machine.
• Remove the float assembly from the recovery tank and clean filter as needed. Replace
float assembly and tank lid.