Dusky D2O Скачать руководство пользователя страница 11

to have to replace.

 The use of a shorting jack for the 

MAIN

 output provides some 

measure of protection if you forget to plug in a speaker cabinet. Mishaps do 
happen, and we're as air­headed as anyone around here. We have accidentally 
run amplifiers without speaker loads for short periods of time with no ill effects. 
We do think, however, that it’s better to be safe than sorry. 

Why isn't there an effects loop? 

Guitar amplifiers that include effects loops as a feature tend to employ a modern 
architecture that uses a high­gain preamp section that can generate distortion 
followed by a high­power, clean power amp used to drive the speaker cabinet. In 
such a case, it can be useful to insert some effects, such as delay and reverb, 
after the preamp so that they can process the already distorted signal before 
passing the signal along to the power amp.  

The D

O Amplifier on the other hand employs a “classic architecture” that 

features a clean preamp that can drive the power amp into distortion with large 
enough signals. Because distortion in the D

O is produced primarily by 

overdriving the power amp section, there is no convenient point to insert an 
effects loop that would allow processing the overdriven signal.  

The D

O Amplifier is often touted as a great clean pedal platform, because of its 

wide bandwidth and robust headroom. If you are looking to add processing to 
your signal after an overdriven stage, we recommend using an external 
processor, such as the Dusky Electronics Toasted Drive, for an overdriven sound. 

Warranty and Service 

If you are the original, registered owner, your Dusky Electronics D

O Amplifier 

comes with a lifetime warranty on workmanship and a 5 year warranty on 
materials 

except for tubes. 

Tubes are warrantied for 6 months. The warranty does 

not cover any accidental damage or damage resulting from abuse, misuse, 
natural or supernatural disasters, or any kind of divine or diabolical intervention. 

Please save all original shipping materials and use the original box and shipping 
materials for shipping the amp should you need service. The customer pays for 
shipping to Dusky Electronics. Dusky Electronics pays for return shipping on 
warranty work. 

You are, of course, welcome to take your Dusky Electronics D

O Amplifier to any 

qualified repair technician for repair, but only Dusky Electronics can perform 
warrantied service. Even out of warranty, we hope you bring it to us. If 

Содержание D2O













Отзывы: