DURKOPP ADLER 550-12-33, Руководство по эксплуатации

Страница: 101 / 200

Programming
Operating Instructions 550-12-33/34 - 00.0 - 08/2017 99
5.6.3 Editing an existing seam program
Important
The changes described in this chapter apply to the entire seam
program rather than the individual seam sections (

p. 102 ).
Information
The setting as to whether the seam program is intended for a
sideless, a left or a right piece cannot be changed. This setting is
adjusted once during the creation of the seam program and cannot
be changed at a later time.
To edit an existing seam program:
1. Switch to edit mode (

p. 90 ).
Selecting the desired left/right piece
If no sideless, but a left and a right piece have been programmed,
select the desired piece.
2. Use
◄
/
►
to switch to the / selection.
3. Use
▲
/
▼
to select the left or the right piece.
L
= left piece
R
= right piece
The seam program of the selected piece is edited.