6
Effectuating the settings on the control unit
Prerequisite: Software level 5321 K or higher
Can be checked with parameter 179.
In case the software level is lower than K load a new control
software (see operating instructions for the sewing drive).
The following parameters have to be set on the control unit:
F-13 =1
Thread trimmer on/off
F-100= 2
Number of soft start stitches (change
from 1 to 2)
F-115=250
Softstart speed (change from 400 to 250)
F-116=140
Trimming speed (change from 150 to 140)
F-134 =1
Soft start on/off
F-136=2
Short thread trimmer stitch
F-154=8
Function thread clamp
F-180=45
Reversing angle
F-181=20
Switch-on delay of reverse motor rotation
(change from 0 to 20)
F-182=1
Reverse motor rotation on/off
Note:
The functions “thread clamp” and “neat seam beginning” are not
yet active at the first sewing start after switching on the control
unit.
The functions are activated only after the first thread trimming.
Anbauanleitung für Teilesatz "Sauberer Nahtanfang"
0867 591004
Fitting Instruction for "Neat Seam Beginning"
0867 591004
Teile-Nr./ Part-No.:
0791 867708
Blatt:
von
Sheet: 24 from 24
Ausgabe/Edition:
06.2010
Änderungsindex
Rev. index: 00.0
Printed in Germany
