Durite O-649-70 Скачать руководство пользователя страница 3

1.

Check before using the product that there is at least 60% charge state. If there is not do not attempt to start the

 

vehicle until the unit is fully charged.

2.

Do NOT crank the engine for more than 3 seconds using the product.

3.

Please wait at least 2 minutes before trying to crank the engine again if it does not start.

4.

Make sure the voltage is selected before connecting to a vehicle battery.

5.

Do not connect the RED Clamp to the earth terminal on battery and vice versa as this will lead to short circuit. It

 

could damage the product and further be dangerous to the user.

6.

Remove the jump starter immediately on starting the vehicle.

7.

Always check that the jumper clamps are connected correctly. Check the vehicle battery terminals to ensure they

 

are not rusty/dirty. If so clean before attempting to connect and jump the vehicle.

8.

If the vehicle does not start on the third attempt please do not try again as this will damage the unit and will void

 

the warranty.

9.

If the unit enters its 'protected state' please press and hold the 'power' button to reset the unit.

10.

 This unit has no serviceable parts inside. Please do not try to open/dissemble the unit as this could be 

dangerous

 

and will void the warranty.

11.

MUST NOT BE USED TO JUMP START ANY VEHICLE WITH A LITHIUM ION BATTERY INSTALLED - RISK OF 

DAM-AGE OR INJURY!

12.

Do not use the unit if it has been dropped or damaged.

13. Do not charge for more than 1.5 hour charging USB 5V3A. If charging from car battery remove after 3 minutes.

14.

Jump for 12V/24V vehicles only. It is forbidden to use for other machines such as aircraftship and so on.

15.

DO NOT use this unit if any cable clamp or cord is damaged.

16.

DO NOT use in place of a vehicle battery.

17.

DO NOT use as a battery charger.

18.

Do NOT operate the product in explosive atmospheres, such as in the presence of flammable liquids, gases or

 

dust.

19.

Do NOT expose product to extreme heat or fire.

20.

Make sure someone is within range of your voice or close enough to come to your aid when working with 

batter-ies.

21.

Remove personal metal items like rings, bracelets, necklaces, etc. When using the products.

22.

Do NOT store in locations where the temperature may exceed 60°C

23.

Charge only at ambient temperature between 0°C and 45°C.

24.

Charge only using the charger provided with this unit.

25.

Do NOT use the unit to jump start a vehicle while charging the internal battery.

26.

If this unit is leaking liquid dispose of at a proper recycle facility immediately.

27.

Under extreme conditions, battery leakage can occur. If a liquid is noticed coming from product do not handle

 

with bare hands. In case of skin contact wash with soap and water immediately. If liquid comes in contact with eyes

 

rinse eyes with cold running water for at least 10 minutes and get medical attention immediately.

28.

Product contains super capacitor, at end of product life dispose of product according to local regulation.

Содержание O-649-70








Отзывы: