Durite 0-776-81, Инструкция по эксплуатации

Страница: 12 / 48

0-776-81-LEAF
www.durite.co.uk
Page 12
Make sure the power switch is turned on or turned off, if it is turned on, please use the key,
turn the indentation to the “turn off” position.
- Remove the front panel of the hard drive box. Get out the hard drive and place it on the
table.
- Set down the two screws of the hard drive by phillips-screwdriver.
- Remove the under backer of hard drive box, and then check the line whether it is on top of
the under backer or not.
- Bring the SATA hard drive which needs installation; connect the line joint of hard drive
box to the hard drive. Please note the heading of the line while connecting. Make sure all of
the connecting is complete done.
- Put the hard drive in the hard drive box. The hard drive needs to lie in the right position.
- Screw the four white screws of the machine through the center hole of the four shock-
proof rubber pads. Fix hard drive on the four holes of hard drive box, do not make the
screws too tight, leave a little space for hard drive to move.
- Insert the hard drive under backer which has hard drive to the hard drive top backer, and
then, use phillips screwdriver and the screws to fix the under backer and the top backer.
- Aim the hard drive box towards the groove of the front board, level push. Please note the
face and back while pushing. Upturn the silk-screen on the right position.
- Wring the lock of the front board by key. Turn the groove on the “turn on” position, lock
hard drive box to prevent hard drive from moving out.
Note : Hard drive fixing lock besides fixing the hard drive, also take the place of main pow -
er switch. So do this operation, make sure all lines are completely connected. Otherwise,
if car‘s power have been connected with the standard input voltage, the machine could be
destroyed. So while installation, if the line has not been completely connected, please stop
to do this step. More careful when installation. The hard drive can not roll out even it has
not been locked.
Note : If fitting the DVR with a HDD (Hard Disk Drive) as memory storage opposed to SSD
(Solid State Drive) the DVR MUST be mounted horizontal in order not to damage the HDD.
HDD can be susceptible to damage from vibration if not mounted in the correct orientation.
This is due to delicate components inside the units. Please mount the DVR flat when using
a HDD.