PLEASE KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE
Duren Tools
T: 01582 484875 E: [email protected]
www.duren.co.uk
Safety Instructions
These instructions are intended as a guide to the correct use of this equipment. The process or materials being
polished may have risk characteristics requiring additional safety measures and these must be identified by the
user. All users of this polisher must be thoroughly acquainted with this manual.
Before Use and Before Using Tool for the First Time
- Make sure you have the relevant Personal Protection Equipment (PPE).
Hand Protection
The pad revolves at high speed and may cause damage if bought into contact with
exposed flesh. The workpiece and the pad may also get hot after prolonged use. Hand
protection must be strong enough to protect the skin and be a good fit and have no loose
parts that may get caught in rotating parts.
Eye and Breathing Protection
The polishing process may create dust and other airborne particles. There is no dust
extraction function on this machine so it is essential that approved eye and breathing
protection is worn.
Noise and Ear Protection
Depending on the material being worked on and the type of polishing disc used, noise
levels may cause hearing damage including temporary or even permanent hearing loss.
It is recommended that Ear Protection is worn at all times when using the polisher.
Repetitive Strain Injury (RSI)
All products of this nature can cause RSI if used for long period, particulary in an
awkward operating position. Adequate rest periods and working conditions should be
considered for prolonged use.
Electrical Safety Instructions
The owner and/or the operator MUST read, understand and comply all points listed below.
1
You MUST check all electrical products, before use, to ensure that they are safe.
2
You MUST inspect plugs, sockets, power leads and any other connectors for wear or damage.
3
You MUST have any worn or damaged plugs, sockets and power leads replaced immediately
upon discovery.
4
You MUST ensure that the risk of electric shock is minimised by the installation of appropriate
safety devices.
5
A Residual Current Circuit Breaker (RCCB) should be incorporated in the main distribution board. - If
no RCCB is fitted, use of a Residual Current Device (RCD) is strongly recommended. If you are
unsure, speak to a qualified electrician and have an RCCB fitted if necessary.
6
RCDs are available from most electrical retailers.
7
The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the
safe condition of those appliances and the safety of the appliance operators. If in any doubt about
electrical safety, seek advice from the governing body or independent electrical training providers.
8
Ensure that the insulation on all cables and on the appliance are safe and intact before connecting it
to the power supply.
9
Ensure that cables are always protected against short circuit and overload.
10
Regularly inspect power supply cables and plugs for wear or damage and check all connections to
ensure that none is loose or damaged.
11
Ensure that the voltage rating of the compressor matches your power supply and that the plug is fitted
with the correct fuse.
12
Do not yank the plug from the socket as can cause damage to both plug and socket. Any damage to
plugs or sockets is potentially lethal.
13
Never carry any electrical tool by it’s power lead.
14
If you are using an extension reel, ensure that it is fully unwound and that an RCD is fitted. A
minimum cable core of 1.5mm2 is recommended although a core of 2.5mm2 will ensure that heavy
loads can be handled. Your extension reel needs to be marked for outdoor use if working outside.
*MSDS
Material Safety Data Sheet
321286_Product Instructions 28/11/2013 16:30 Page 3