21
8. Maintenance
Residual-current circuit-breaker
Check the residual current circuit breaker (RCD) regularly as described in its operating
instructions.
9. Troubleshooting Support
cAUTIoN
The whirltub may be repaired only by a qualified plumber and/or
electrician.
Problem
Potential cause
Solution
Foaming
Soap or shampoo in the bath-
water.
>
Switch off the whirltub
system.
>
Fill the tub with fresh water.
Whirltub system runs only
briefly.
Water level too low.
>
Add water until the water
level is about 5 cm above the
uppermost jet.
>
Press the "Jet" button for a
while.
Whirltub system does not
start.
Mains switch is switched off.
>
Switch on at the mains.
Mains fuse is switched off.
>
Switch on the mains circuit
breaker.
Ground-fault switch (RCD) or
circuit breaker has tripped.
>
Disconnect the tub from the
mains.
>
Call customer service.
10. Technical Data
10.1 Identification Plate
The identification plate is on the back page of the operating instructions or in the tech-
nical area of the whirltub.
This product conforms to all the appropriate EU guidelines.
DIN EN 12764, DIN EN 60335-2-60, IEC 60335-2-60