22
Problem
Potential cause
Solution
Whirl system does not start? Mains switch switched off.
>
Switch on at mains.
Mains fuse is switched off.
>
Switch on mains
circuit breaker.
Ground-faultswitch (RCD) or
circuit breaker has tripped.
>
Disconnect tub from mains.
>
Call Customer Service.
Buttons do not function
properly?
Air in button after whirl sy-
stem has been standing idle.
>
Press button once again.
Sound of motor during filling
/ after draining the tub (2nd
floor)
Residual water drain lines are
being opened / closed.
Sound volume / quality can-
not be changed.
Data not compatible.
>
Check whether the audio
source supports the A2DP
protocol.
8. Technical Data
8.1 Identification Plate
The identification plate is on the back page of the Operators Manual.
This product conforms to all the appropriate EU guidelines.
DIN EN 12764
8.2 Specifications
Rated voltage
220-240 V ~ (AC)
Frequency
76xxxxx xx x xx xx00:
50 Hz
76xxxxx xx x xx xx06:
60 Hz
Max. rated power
see identification plate
Protection type
IP X5
Protection against sprayed water
(from any direction)
Protection
class
1
