❏
1. Remove the Thunder Quake, transmitter and parts
from the box.
❏
2. Remove the twist-tie from the receiver antenna wire. The
receiver antenna wire is a bundled thin wire that is attached
to the receiver. Run the length of the antenna wire through
your fingers to help straighten the wire out, this will make it
easier to get the wire through the tube. Remove the antenna
tube from the decal bag. Slide the antenna wire through the
antenna tube. Do not coil or cut the antenna. Cut two
pieces of fuel tubing 1/8" wide and slide them over the outside
of the antenna tube and wire. This is to help hold the antenna
tube on and avoid getting the antenna wire cut in a roll over.
Note the placement of the tubing on the antenna tube.
❏
3. Remove the air filter parts from the parts pack.
Remove the flat head self-tapping screw from the top of the
air filter and remove the plastic top. Remove the air filter
element and thoroughly soak it in air filter oil, light machine
oil, or (in a pinch) shock oil. Reinstall the air filter element,
plastic top and flat head self-tapping screw.
❏
4. Press the “L” shaped boot onto the bottom housing of the
air filter. Using one of the included tie-straps, tightly secure
the boot onto the bottom housing. Cut off the excess portion
of the tie-strap.
❏
5. Place the air filter onto the carburetor. Using the
remaining included tie-strap, tightly secure the air filter to
the carburetor. Cut the excess portion of the tie-strap off to
avoid interference.
AIR FILTER INSTALLATION
ANTENNA INSTALLATION
4
THUNDER QUAKE FINAL ASSEMBLY
