RTR ASSEMBLY
Note: For more detailed instructions, refer to page 4 of
the assembly and operation manual.
RUNNING THE NITRO EVADER
™
1.
Install the included “C”
size battery into the included
glow starter.
2.
Add fuel to the fuel tank using the included fuel bottle.
3.
Turn the transmitter “on” and check that the battery
indicator light is on. If the battery indicator light is not “on”
or is blinking, you need to change your transmitter
batteries before running your Nitro Evader.
4.
Turn on the Nitro Evader.
5.
Make sure the throttle opens all the way when the
throttle is applied on the transmitter. Make sure the brakes
work adequately when the trigger is pushed forward.
6.
Make sure the front wheels of the Nitro Evader move left
and right correctly when the transmitter wheel is turned.
STEERING
TRIM
THROTTLE
TRIM
ADJUSTABLE
STEERING
RATE
Squeeze for
forward
Push for
brake
IMPORTANT: Read the instructions and watch the video for further details
on running and maintaining your new DuraTrax
®
vehicle.
2.
Install (8) “AA” batteries into
the transmitter. Check to make
sure the red power light glows
when the transmitter is on.
3.
Install the receiver
antenna tube. Secure the
excess wire to the tube
using tape. DO NOT CUT
THE ANTENNA WIRE.
4.
Install (4) “AA” batteries into the
receiver battery holder.
5.
Use a tie strap to secure
the batteries in the holder.
1.
Install the transmitter
antenna into the transmitter.
®
™
6.
Decal the body as desired and install on the chassis.
Install the wing wire into the holes in the rear shock tower.
Note: If the wing fits loosely, bend the end of the wires a bit.
