❏
1. Install the “AA” batteries in the transmitter.
❏
2. Install and extend the transmitter antenna.
❏
3. Connect the steering servo and electronic speed control
to the receiver. See your radio instructions to see which
channel is steering (servo) and which is throttle (ESC).
❏
4. Uncoil and extend the receiver antenna.
❏
5. Hook up the charged 6 or 7 cell battery to the electronic
speed control.
❏
6. Adjust the servo trims of the transmitter to the neutral
position (centered).
❏
7. Switch on the transmitter.
❏
8. Switch on the electronic speed control.
❏
9. Set up speed control (see your ESC instructions for the
correct set-up procedure).
❏
10. Operate the steering and throttle control. Make sure the
steering servo arm and motor move in proportion to the
movement of the steering wheel and throttle trigger.
❏
11. Switch off the receiver, then the transmitter.
❏
12. See your radio instructions for set-up and operating the
radio system.
❏
1. Charge the 6- or 7-cell
battery (not included) on
your charger (not included).
See Safety Precautions
before charging. See your
charger's instructions for
proper charging procedure
and charge times.
❏
1. Locate and remove from the parts bag two (2) steering
servo mounts, one (1) servo arm (determine which servo arm
is required for your radio system), one (1) 4-40 ball stud, one
(1) foam washer, two (2) 3x8mm pan head screws and two
(2) 4-40 x 5/16" flat head machined screws To ensure that
you are using the right size screw, match the screw to the
picture on the hardware chart, which is on the separate
exploded view/parts list.
❏
2. Attach the servo mounts to the servo using the two (2)
3x8mm screws as shown.
❏
3. Install the 4-40 ball stud into the flat side of the steering
servo arm in the upper hole. With the steering servo centered
as described in “Preparing the Radio System”, install the
correct steering servo arm onto the servo splines as shown
above. (Note: If the steering servo is not properly centered, the
steering could be off). Re-install the servo horn screw, securing
the horn onto the servo.
STEERING SERVO INSTALLATION
CHARGE YOUR BATTERY
PREPARING THE RADIO SYSTEM
4
