15
4
S
75 (Front)
76 (Rear)
31
122
32
70 (Front)
71 (Rear)
34
77
78
114
114
33
35
68 (Front)
69 (Rear)
Do not overtighten
106
Shock Assembly
1. Install a 2.5mm e-clip (S) onto the groove on the shock shafts (68,69) closest to the center of the shaft. Place
the shock piston (4) on top of the 2.5mm e-clip. Secure the shock piston in place with a 2.5mm e-clip in the
groove closest to the end of the shaft.
2. Install a shock O-ring (114), a shock seal spacer (35), and then another shock O-ring (114) into the bottom of
the shock body (75,76). Secure the parts in the shock body using the shock seal retainer (33).
3. Install the shock shaft assembly into the shock body.
4. Fill the shock with fl uid. Install the shock diaphram (34), the shock cap (78) and the shock cap ring (77).
5. While tightening the shock cap down, work the shock shaft and piston up and down to help remove any air
and excess oil that may be trapped in the shock. Thread the shock ball end (31) onto the end of the shock
shaft.
Note:
To hold the shock shaft, use needle-nose pliers with a piece of cloth (to protect the shaft).
6. Install the shock ball (106) in the shock end.
7. Install the upper spring clamp (122) and spring (70,71).
8. Secure the shock spring in place with the lower spring clamp (31).
1
5
2
6
3
7
4
8
