Charge your 6 or 7-cell battery with your battery charger. Be
sure to follow the instructions supplied with your charger.
1.
1.
4.
4.
2.
2.
3.
3.
READ THE INSTRUCTION MANUAL AND WATCH THE VIDEO FOR FURTHER DETAILS ON RUNNING AND MAINTAINING YOUR EVADER BX.
Screw in the transmitter antenna and install the “AA”
batteries. Check to make sure the red power light glows
when turning the switch “on”.
ON / OFF
POWER
LIGHT
STEERING
TRIM
ADJUSTABLE
STEERING
RATE
THROTTLE
TRIM
Install (8) new "AA" batteries
Install the antenna to the chassis. Secure excess wire to the
tube using tape. DO NOT CUT THE ANTENNA WIRE!!!
Route the antenna
through the chassis
and then through
the tube.
Remove the clip and lift the battery strap. Install the
charged battery pack into the chassis and reinstall the
battery strap and clip. Plug the battery into the connector
on the Electronic Speed Control. ALWAYS DISCONNECT
THE BATTERY PLUGS WHEN FINISHED RUNNING.
Remove the pin and lift
the strap to install/remove
the battery pack.
Install the strap
between the bumps.
Charge the Battery Pack.
Prepare the Transmitter
Install the Antenna Tube
Install the Battery Pack
RTR ASSEMBLY
5.
5.
Place the body onto the chassis. Use clips to secure the
body in place. Install the wing into the rear shock tower.
Install the Body
™
®
This Manual: http://www.manuallib.com/file/2713274
