CLEANING
•
To clean the device, brush off any remaining residue with a soft, fine brush.
•
Clean the surface with a lens cleaning cloth or a clean, soft, lint-free cloth.
•
In order to remove fingerprints and other fat residue, the cloth can be moistened
with water or a lens cleaning solution.
•
Do not use any chemicals, abrasives or solvents that could damage the
magnifying lamp.
•
Never touch the lens with your fingernails or other sharp objects.
SPARE PART SPECIFICATIONS
•
Magnifying glass lens size: 90mm
•
Magnification: 3x
•
LED illumination: 16 pieces patch type LEDs
•
Neck (for magnifying glass) length: 265mm
•
Neck (for alligator clips) length: 250mm
•
Soldering wire spool holder
•
Third hand with alligator clips
•
Soldering iron holder
•
Sponge size: 30 x 50mm
•
Rosin: 10g
•
Cleaning ball
•
Base size: 190 x 170mm
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste
Electrical & Electronic Equipment (WEEE). Any WEEE marked products
must not be mixed with general household waste, but kept separate for the
treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China. PR2 9PP
V.1.0
•
Before use, unscrew the two screws (below) and put the two iron sticks in a
vertical position and tighten the screws again.
•
Open the battery cover and place four 1.5V AA batteries (not included) inside,
before placing the battery cover back in position.
1.
2.
3.
4.
5.
Unscrew the two screws.
The two iron sticks are used to
hold the soldering wire spool.
