Duratool D03128, Руководство пользователя

Страница: 11 / 16

11
MEASURING AC CURRENT
WARNING
• Beware of electrocution.
• Ensure that the test leads are disconnected from the meter before making
current clamp measurements.
• Set the rotary selector to the 40A or 400A range position.
• Push the “ REL ” key to make sure that the LCD displays zero.
• Press the trigger to open the jaw and fully enclose only one conductor.
• Take the reading on the LCD.
Note: Do not put more than one cable into the jaw during the test, otherwise the test
value obtained may be incorrect.
• For optimum results, centre the conductor in the jaw.
• At the manual range mode, when only “OL” is shown on the LCD it means that the
measurement has exceeded the range and a higher range should be selected.
• If the scale of the value to be measured is unknown beforehand, set the range to
the highest.
• “ ” means the maximum input current is 400A rms AC.
MEASURING DC CURRENT
WARNING
• Beware of electrocution.
• Ensure that the test leads are disconnected from the meter before making
current clamp measurements.
• Set the rotary selector to the 40A or 400A range position.
• Press the “ SEL ” key and turn to DC current measurement mode.
• Press the “ REL ” button and the meter will be set to zero.
• Press the trigger to open the jaw and fully
enclose only one conductor.
• Take the reading on the LCD.
• “-” will be displayed on the LCD if the
direction of the current is negative.
Note: Do not put more than one cable into the
jaw during the test, otherwise the test value
obtained may be incorrect.
• For optimum results, centre the conductor
in the jaw.
• At the manual range mode, when only
“OL” or “-OL” is shown on the LCD,
it means that the measurement has
exceeded the range and a higher range
should be selected.
• Under the manual range mode, when
the scale of the value to be measured is
unknown beforehand, set the range to the
highest.
• “ ” means the maximum input current is
400A DC.
Correct Incorrect